Windows driver issue
Symptoms:
- Board is detected and automatically connected to GCS,
- Board information after Firmware Rescue is correct,
- No Rx data received, only Tx data
Possible solution:
- Control Panel -> Device Manager
- Expand "Universal Serial Bus controllers"
- Most likely you will have one or more"USB Composite Device"
- Right click -> Properties each "USB Composite Device" listed and note its "Location", each has a unique location.
- Plug in CC3D, do not launch GCS.
- You now have one new "USB Composite Device", Identity which one is the new one by Right click -> Properties
- Uninstall this new "USB Composite Device" ie your CC3D by Right click -> Uninstall
- Unplug CC3D from USB Port
- Plug in CC3D and let windows reinstall driver. You'll hear the Windows Device Discovery tones indicating the device is successfully installed.
- Launch GCS, all should be good now.