...
- vibration free setup
- correct linkages lenght and angles
- smooth moving pushrods
- secured screwscrews
- correct adjusted belt tension (if applicable)
- safe attached FC
- unsecured cables
...
After verifying that all servos are moving correct reconnect the linkages to the servo horns and restart the wizard. The neutral position of the servos horns is already set, so adjust the linkages to level the swashplate. Verify also the maximum position (+15°) and minimum position (-15°). Keep in mind that collective and cyclic will mixed (added) together by a 50% multiplier on each component. So the pre setup swashplate travel of -15° to 15° will result in a effective travel of -7.5° to +7.5° travel plus the cyclic signal. Dont forget to level the swashplate at the maximum and minimum position. Use only the slider to change the values, if you enter the position directly and with values out of the servo move range you can easy destroy your swashplate servos. After setting up the swashplate your output screen may look litke this:
...