Work in progress
The Revolution is a full 10DoF flight controller board capable of stabilizing various aircrafts ranging from small racing miniquads to large FPV fixed wing models and aerial photography platforms.
Along side standard stabilization modes it also supports various GPS assisted modes and GPS navigation flight.
Hardware Description
CPU
Main processor is a STM32F405RGT6 ARM Cortex-M4 microcontroller.
...
36x36mm with 30,5x30,5mm hole spacing
Connectivity
Powering the board
...
Pin | Wire Color | PPM In | PWM In | Telemetry | PWM Out | |||||
---|---|---|---|---|---|---|---|---|---|---|
1 | Black | GND | ||||||||
2 | Red | Vcc (4,8-15V DC) | ||||||||
3 | ||||||||||
4 | ||||||||||
5 | White | PPM In | PWM In 1 | PWM Out 12 | ||||||
6 | Blue | PWM In 2 | PWM Out 7 | |||||||
7 | Yellow | PWM In 3 | Tx | PWM Out 8 | ||||||
8 | Green | PWM In 4 | Rx | PWM Out 9 | ||||||
9 | Orange | PWM In 5 | PWM Out 10 | |||||||
10 | Violet | PWM In 6 | PWM Out 11 |
Main Port
This is a UART serial port with a programmable inverter on the Rx pin. It can be used to connect various serial devices such as GPS receiver, OSD, Telemetry (Bluetooth, OPLink, etc.), S.Bus receiver, DSM satellite receiver...
...
Pin | Wire Color | Telemetry | GPS | OSD | DSM | S.Bus | ||||
---|---|---|---|---|---|---|---|---|---|---|
1 | Black | GND | ||||||||
2 | Red | Vcc (4,8-15V DC) | ||||||||
3 | Blue | Tx | ||||||||
4 | Orange | Rx | DSM In | S.Bus In |
Info |
---|
The Tx and Rx lines between the controller and device must be connected: Rx to Tx and Tx to Rx. If you connect Rx to Rx and Tx to Tx, serial communication will not work. |
...
Pin | Wire Color | Telemetry | GPS | OSD | DSM | SRXL | I2C | ||||
---|---|---|---|---|---|---|---|---|---|---|---|
1 | Black | GND | |||||||||
2 | Red | Vcc (4,8-15V DC) | |||||||||
3 | Blue | Tx | SCL | ||||||||
4 | Orange | Rx | DSM In | SRXL In | SDA |
...
The conector used is a 4pin JST-SH.
Pinout:
Pin | Analog In | ||
---|---|---|---|
1 | GND | ||
2 | Vcc | ||
3 | ADC 0 | ||
4 | ADC 1 |
...
Antenna Connector
...
433MHz antenna for the integrated modem should be connected here.
...