...
| Section |
|---|
| Column |
|---|
| Receiver PortThis port is used to interface with the RC receiver using all "one wire" input protocols. - PPM
- S.Bus
- Spektrum DSM
- Multiplex SRXL
- Graupner Hott
- Jeti Ex.Bus
- FlySky IBus
The Sparky2 board do not support PWM inputs. |
| Column |
|---|
|  Image Modified
|
|
...
| Section |
|---|
| Column |
|---|
| Flexi PortCan be disabled, or connected to one of the following: GPS, Telemetry, I2C, OsdHk or a Debug Console. Main PortCan be left disabled, or connected to telemetry, GPS or a Debug Console. I2C PortCan be disabled, or used as I2C port. Made flexiPort free for other usage.
This port is available in a back side of the flight controller. MainPort / FlexiPort / I2CPort pinOut| Color | Pin | Electrical limits | Serial function | I2C function |
|---|
| Black | 1 | GND | GND | GND | | Red | 2 | 4.8V - 15V | PWR Out (VCC Unregulated) | PWR Out (VCC Unregulated) | | Blue | 3 | 3.3V | TX | SCL | | Orange | 4 | 3.3V (5V Tolerant) | RX | SDA |
|
| Column |
|---|
|
 Image Modified
 Image Modified
|
|
...
LED Port
| Section |
|---|
| Column |
|---|
| The LED port provides buffered outputs that can be used for led or brushed motors. See the Sparky2 page in Taulabs wiki for more details. The normal PWM output signal can be picked before the mosfets for servo or Esc usage. |
| Column |
|---|
|  Image Modified
|
|
...
| Section |
|---|
| Column |
|---|
| Power Port| JST connector | Connector pin (board) | Description |
|---|
 Image Modified | 1 | GND | | 2 | Ana / DAC | | 3 | Current Input | | 4 | Voltage Input |
See the Configure a Current-Voltage sensor page for more details |
|
...
| Warning |
|---|
| Any sensor can be used as long as the input voltage to Revo's Sensor Port pins does not exceed 3.3V. Higher values can damage board's CPU!
Normal Revolution board has ESD chips that prevent for over voltage. |
|
| Column |
|---|
|  Image Added
|
|
.
...
USB HID Function
Configurable for use as Telemetry over the USB port
...