RC Transmitter Wizard
Introduction
Transmitter wizard helps the user:
- to assign channel inputs with stick functions. e.g. channel 1 < > Throttle stick
- set the min / neutral / maximum values for every input.
Video example
Check the video bellow that show a RC Transmitter setup :
RcInput : SBus
Transmitter : FrSky Taranis
Four Tx controls, one flight mode and four accessories.
In most cases the four Tx controls and flightmode are mandatory, except for ground vehicles.
Frequently Asked Questions
Nothing works
After the Transmitter Wizard is started, no activity and the Throttle (first stick to be detected) is not detected.
Power
Be sure the receiver is powered using a external source, the USB port only power the board.
Binding
Double check the receiver binding, if PWM a servo can be used for testing receiver outputs.
Wiring
Check the receiver wiring, go here and select the board you use.
You can find some receiver connection diagram examples.
Reboot
Be sure you rebooted the board after a change in Hardware tab (e.g. set the input to PPM).
For correct reboot you need to disconnect board from external power source and USB port.
Usually the SystemHealth panel tell you you need to reboot with a red alarm.
