In this section you first need to find a terminal software to talk trough serial connection with your bluetooth module. For Window systems : PuTTY, under Linux try Cutecom or PuTTY, and for MacOSX try CoolTerm
Configure your terminal for 9600 baud rate, 8 data bit, 1 stop bit & no parity serial connection. Also be sure to setup "No line end" for data sent. - Send AT command and module should answer OK on receive window
- Set name, send AT+NAMEMybluetoothName where MybluetoothName is the name you choose.
- Set baudrate using the AT+BAUD command: AT+BAUD7 set baudrate to 57600bds. (if you need 38400 you should send AT+BAUD6)
- Module answer is OK57600
- At this point you need to change baudrate and talk again with bluetooth module.
If later you need to talk with bluetooth module using a FTDI adapter you only need to change baudrate in terminal settings.
|