Return to base

The Return to Base (RTB) flight mode uses the full range of sensors available on controller to accurately return to the Take Off Location without any pilot input.

This assumes the Home Location is set correctly and previously a basic PositionHold mode works perfectly.

CC3D GPS Navigation

CC3D and Atom boards do not support GPS navigation features like RTH, PosHold, waypoints...


Only Revolution, Revolution Nano and Sparky2 can use GPS for navigation.

In this page

    



Set Attitude Estimation Algorithm

To use all the navigation features using GPS,select the GPS navigation (INS13) attitude estimation algorithm

Go into Attitude page > SettingsAttitude Estimation Algorithm, select GPS Navigation INS13, and Save.




Set the flight mode

Go into Input page > Flight Mode Switch Settings and affect ReturnToBase to one flight mode position.

When engaged, Return to Take Off Location in a straight line and stay into Position Hold when it gets there without user input.


 


Optional settings


Return to base altitude offset

By default, the vehicle will climb to 10 meters above its current position when the Return To Base flight mode is activated. This add a margin of safety for the return flight in order to avoid obstacles.

Value of offset can be set in UAVOBrowser: System tab > Settings > FlightModeSettings > ReturnToBaseAltitudeOffset. and value in meters.

Save settings using  button.


Take Off Location mode

TakeOffLocation can be configured to return to either the ArmingLocation, or FirstArmingLocation.

Value can be set in UAVOBrowser: System tab > Settings > TakeOffLocation > Mode 

The default setting to "ArmingLocation" to return to the point of takeoff is recommended in most instances.

Save settings using  button.


Return to base next command


This option only applies to Multirotors, after a Return to Base the default behavior is Hold position when Home position is reached.

Another alternative is a Land phase after Return to Base.

Value can be set in UAVOBrowser: System tab > Settings > FlightModeSettings > ReturnToBaseNextCommand. and choose between Hold or Land.


Save settings using  button.