Versions Compared

Old Version 5

changes.mady.by.user Lalanne Laurent

Saved on

compared with

New Version 6

changes.mady.by.user Lalanne Laurent

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Frequently Asked Questions

...

Section

Nothing works


Nothing works
Column
width60%

After the Transmitter Wizard is started, no activity and the Throttle (first stick to be detected) is not detected.

Power

Be sure the receiver is powered using a external source, the USB port only power the board.

Binding

Double check the receiver binding, if PWM a servo can be used for testing receiver outputs.

Wiring

Check the receiver wiring, go here and select the board you use.
You can find some receiver connection diagram examples.



Column
width40%

Section
Column
width60%
Reboot

Be sure you rebooted the board after a change in Hardware tab (e.g. set the input to PPM).
For correct reboot you need to disconnect board from external power source and USB port.
Usually the SystemHealth panel tell you you need to reboot with a red alarm.


Column
width40%


...


Section

Partially works


Partially works
Column
width60%

After the Transmitter Wizard is started, some sticks are not detected.

One primary stick not working

If PWM input: Swap wires and check if the same issue still.

In some cases one channel is wrongly detected as a stick due to a channel with jitter.
Resolve jitter issue or do the channel <> stick function mapping manually, using the Receiver Activity information.

Flight mode - Accessory issue

Be sure your flight mode switch or accessory knob/switch is assigned to one receiver output.
Configure your transmitter according to the manual.
Check the monitor output screen in your transmitter.

Flicker the flight mode switch quickly when asked.



Column
width40%


...