Versions Compared


  • This line was added.
  • This line was removed.
  • Formatting was changed.


  1. Disconnect all power to the board. The board should not be supplied by any other power supply (no LiPo!)  The board will not enter bootloader mode being powered from another source.
  2. Click the Rescue button in the top button area.
  3. You will be instructed to connect your Flight Controller board.
  4. The Uploader Gadget will detect your connected board and show the bootloader and firmware versions.

  5. You can now load the desired bootloader or firmware file using the "Open" button

  6. Pressing the button Flash will update the firmware on your board. A progress indicator shows the actual status of the firmware upgrade and identifies if the upload has been successful.

  7. Once the firmware has been upgraded, one has to click Boot in the buttons area to start the program on the board