Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Section
Column
width60%

 This page describes how to setup the Rattitude mode.

Introduction

Rattitude is a hybrid mode which gives you the stability of Attitude mode, but will allow you to preform flips, rolls by switching automatically from Attitude mode to Rate mode when your stick movement passes a certain percentage.

It reverts back to Attitude when your stick comes back past that same percentage, when you leave stick to center after a flip for example.

Rattitude mode can be combined successfully with Cruise Control.

Column
width40%
Panel
titleIn this page
Table of Contents

...

Section
Column
width60%

Advanced tab

Tick the "Use advanced configuration" checkbox.

This advanced tab give more control over settings, attitude mode response and rates can be different between Roll and Pitch axis.

Current default settings are not recommended while using the Rattitude hybrid mode, rate response are two too slow for safe flips or rolls.

Go to next part bellow.

 

Column
width40%

 

...

Widget Connector
width800
urlhttps://www.youtube.com/watch?v=LbTjWaZbBA8
height600480

 

...

 

Section
Column
width60%

Rattitude settings

Go to Configuration > Stabilization tab > Expert tab (please note the Mode transition value is not defined per PID bank, but a global value)

The mode transition refers to the percentage of full stick level where the Rattitude mode switches from attitude to rate.

Default setting is 80%, it can be lowered a little for faster turn in rate mode. Small values are dangerous because they cause flips at small stick angles, keep safe values in 60-80% range. A mode transition value set to 100% act like Attitude mode, vehicle never flips.

 

Column
width40%

 

...