Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Section


Column
width80%

Introduction

All F3 boards (SPracingF3, SPracingF3Evo, PikoBLX, tinyFISH FC...) comes usually with BetaFLight BetaFlight firmware flashed on it.

We need to flash LibrePilot bootloader before firmware update using GCS.

Warning
titleF3 support

Currently only the Next branch supports all the F3 boards



Column
width250px


Panel
titleIn this page

Table of Contents
indent15px



...

Section


Column
width60%

After you flashed the bootloader, the board does nothing because there is no firmware running, only a slow fading led blinking.

Steps for firmware update:

  • Disconnect board from the USB port and disconnect external power (Lipo) if any.,
  • Click the 'Upgrade&Erase' button. (Board still disconnected)
  • Connect board to the USB port

The board will:

  • be recognized just after connected to the USB port,
  • flashed using the appropriate firmware for the board (according to the bootloader you flashed previously),
  • reboot and erase settings,
  • and finally remains connected, running the new firmware that matches your GCS.


Column
width40%

Image RemovedImage Added


...