Versions Compared

Old Version 5

changes.mady.by.user Lalanne Laurent

Saved on

compared with

New Version 6

changes.mady.by.user Harold Hankins

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Section
Column
width60%
 

This page describes how to recover a board using DFU mode, this procedure only applies to DFU capable devices like Revolution, RevoNano or Sparky2 boards.

Unfortunately, the CPU used on the CC3D flight controller do does not support the DFU bootloader, see this page instead.

 

During production of the STM32 micro-controller, a low level bootloader is programmed into the device as part of the process.  One of the serial communication interfaces on which this bootloader is available is the USB port and it supports the DFU protocol. 

The only hardware required is your flight controller and a USB cable.

Column
width40%
Panel
titleIn this page
Table of Contents

...

Section

Prepare board for DFU mode

You need to short the two SBL pads in your flight controller.

Pictures below show SBL pads location for Revolution, RevoNano and Sparky2 boards:

Be careful, in some cases there is others components around.

Put a solder joint only between the two pads!


After is done the controller will show only one led on (the power led) and the other leds do not blink anymore because the internal boot loader does not control it at all.

...