Sometimes it is difficult to determine the arming state from the blinking of the internal LED.
...
Configure one output channel (in the image, it is pin [5], which is the 6th pin on the CC3D) with the values above.
Be sure to configure the correct bank for the BankUpdateFreq Setting setting and the BankMode Setting setting for the chosen channel/pin.
You can see which channel corresponds to which bank on the configuration output page of the GCS.
...
The RGROUND resistor should be 10k Ω. As a MOSFET, you can use a 2N7000 transistor. This configuration works for a 3S LiPo (max 12.6V).
Example for the worst possible hardware implementation.
Result
This configuration will blink once every few seconds while disarmed, and twice while armed.
Widget Connector width 800 url http://youtube.com/watch?v=YuUwTSMB350 height 600
Related articles
Filter by label (Content by label) | ||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
...