Search

Help

Page 1 of 1. Showing 8 results (0.08 seconds)

  1. Setup a bluetooth for telemetry

    HC-05 or HC-06 bluetooth modules can be used, it allow a short range wireless link with your board or Oplink as Rc module. hc-05.jpg … CC3D_bluetooth_combridge_cnx.JPG Configuring the bluetooth module To configure the Bluetooth module, you must connect to the module with a serial link. You can
    LibrePilot DocumentationJan 13, 2017
  2. Re: Setup a bluetooth for telemetry

    :                                         http://www.ftdichip.com/Drivers/VCP.htm http://www.ftdichip.com/Drivers/VCP.htm The Bluetooth module that I have:(DSD TECH HC …-05 Bluetooth Serial Pass-through Module) required that the button on the module be held down while powering up by plugging into the computer's USB port. The USB
  3. Re: OPLink Configuration

    Be advised. If you are using a Mac to connect to your bluetooth module you have to go to System Preferences\Security & Privacy\General - then allow apps … to be download from Anywhere to be able to connect to your HC-05 or HC-06 bluetooth module! 
  4. LibrePilot2Go Android App

    .   https://camo.githubusercontent.com/e7eeb0cdc46981fb9c54402b4973a19cc76a27ff/68747470733a2f2f692e696d6775722e636f6d2f41707a4e3075352e706e67 You need a special cable. Search amazon for "otg", for example. Bluetooth … With this connection, the android device connects directly to a Bluetooth serial telemetry link on the flight controller or to an OPLink module. Read
    LibrePilot DocumentationMar 05, 2017
  5. OPLink Configuration

     PPM_only_slave_wiring.png Telemetry + Remote Control + Bluetooth Telemetry_PPM_Bluetooth.png This configuration allow a "wireless" setup with remote control and telemetry … back to computer. This need a Bluetooth module already setup for 57600bauds. See how to configure the Bluetooth module in this page. Ground OPlink setup
    LibrePilot DocumentationDec 18, 2016
  6. OpenPilot Revolution Nano

    of ESCs integrated BECs or an external 5V BEC. The voltage used to power the board will also power any peripheral devices like GPS, Bluetooth modem,... connected … receiver, OSD, Telemetry (Bluetooth, OPLink, etc.), S.Bus receiver, DSM satellite receiver... The connector used is a 4pin JST-SH. Pinout: Pin Wire Color
    LibrePilot DocumentationJul 14, 2017
  7. OpenPilot Revolution

    BEC. The voltage used to power the board will also power any peripheral devices like GPS, Bluetooth modem,... connected to it. All input/output (Rx, Tx, PWM, etc … receiver, OSD, Telemetry (Bluetooth, OPLink, etc.), S.Bus receiver, DSM satellite receiver... The conector used is a 4pin JST-SH. Pinout: Pin Wire Color
    LibrePilot DocumentationAug 03, 2017
  8. Sensor calibration

    outdoors, Oplink or Bluetooth connection give best results. After mag calibration is successful, save calibration results with Save button
    LibrePilot DocumentationJul 08, 2016